Verilink WANsuite 7105 (34-00316.C) Product Manual Bedienungsanleitung Seite 233

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 255
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 232
VT100 Interface 4-99
TFTP Configuration Screen
To transfer a file to or from a TFTP server from a WANsuite unit, you must
indicate the TFTP server’s IP address and file name, and then perform a Get
operation to receive a file from the server, or a Put operation to send a file to
the server. The file name and its extension determine the type of file
transferred.
The table below shows the possible file operations.
Note that when updating the application software using a .HEX file, the file
name should have the form xxAPxxxx.HEX; the AP indicates the file is an
application load. When updating the boot software, the file name should have
the form xxWBxxxx.HEX; the WB indicates the file is a boot load.
Figure 4.94
TFTP Configuration Screen
TFTP Server IP
Address
IP address of the server providing TFTP access.
File Name
Name of the file to be transferred.
Status
Indicates the current status of the TFTP operation. Possible values include
Idle, Getting File, Putting File, Aborting, Transfer Complete, Invalid File
Name, and Invalid File.
Operation File Name Extension Action
Update Application Firmware .CHX or .HEX(1) Get
Update Boot Firmware .HEX(2) Get
Save Configuration Setup .CFG Put
Restore Configuration Setup .CFG Get
Seitenansicht 232
1 2 ... 228 229 230 231 232 233 234 235 236 237 238 ... 254 255

Kommentare zu diesen Handbüchern

Keine Kommentare